Welcome to DU! The truly grassroots left-of-center political community where regular people, not algorithms, drive the discussions and set the standards. Join the community: Create a free account Support DU (and get rid of ads!): Become a Star Member Latest Breaking News Editorials & Other Articles General Discussion The DU Lounge All Forums Issue Forums Culture Forums Alliance Forums Region Forums Support Forums Help & Search

Ruby the Liberal

(26,331 posts)
Fri Mar 23, 2012, 11:35 PM Mar 2012

Adding a humidifier to a heat pump?

The dry skin is going to make me insane if I don't end up with an infection from scratching first.

My installation is a 13 SEER Carrier heat pump/AC unit and I have a standalone room humidifier for overnight, but have had recommendations on this install (noting the cautions about mold and other airborne issues).

Any thoughts, suggestions, recommendations?

4 replies = new reply since forum marked as read
Highlight: NoneDon't highlight anything 5 newestHighlight 5 most recent replies
Adding a humidifier to a heat pump? (Original Post) Ruby the Liberal Mar 2012 OP
It's a pretty straightforward situation jeff47 Mar 2012 #1
My heat pump unit is in an upstairs closet Ruby the Liberal Mar 2012 #2
Most units are roughly 12" by 16" by 4" jeff47 Mar 2012 #3
Ah! Interesting and very helpful. Ruby the Liberal Mar 2012 #4

jeff47

(26,549 posts)
1. It's a pretty straightforward situation
Sat Mar 24, 2012, 07:36 PM
Mar 2012

I'm not sure what sort of thoughts you're looking for. There really isn't anything tricky.

You'll just need to remember to turn it off during the summer.

Ruby the Liberal

(26,331 posts)
2. My heat pump unit is in an upstairs closet
Sat Mar 24, 2012, 10:44 PM
Mar 2012

that was almost built around it.

Do they take up a lot of room? Is this something a handyman can do, or should an HVAC be called?

Also, if you know - how do they work? In googling I see references to humidifier controls (like temperature controls) to ensure that there isn't too much moisture as it can lead to mold issues and an increase in a potential dustmite problem. Is this something that can be combined with a thermostat, or do they have to fish the wires through the wall for a separate control?

Since I have you - are there options, and if so, what to look for/ask for, and more importantly - what corners shouldn't be cut for an ill thought cost-saving desire?

Just trying to understand this so I know who I should call and if what they are telling me gels with what people who understand this have advised. An elderly relative suggested this to me this week but couldn't speak to the particulars.

I don't want to pay $1,000 for something that can be accomplished for $500, but in the same token, I don't want to pay $500 for something that, done right, should cost $1,000. If that makes sense?

jeff47

(26,549 posts)
3. Most units are roughly 12" by 16" by 4"
Sun Mar 25, 2012, 01:02 PM
Mar 2012

So it's usually possible to fit them into any HVAC space. The hard part is you need a supply of water - somebody's got to run a pipe to the humidifier. Some use small tubing, which is much easier than real plumbing. But there's some problems with that - tubing isn't as durable as pipe, so it's more likely to leak.

It is something a handyman can install, just read the directions first.

They way they work is they spray water into the air that is passing through the blower. That water evaporates and thus increases the humidity of the air.

As for the humidity controls, they're usually set to put a fixed rate of water into the air. Calculations in the instruction manual will give you a good starting point for that setting. You can tweak the rate based on how the house feels, or you could use a hand-held humidity meter.

It is possible to get a humidistat and put that out in the house similar to a thermostat. That tends to be overkill - if the temperature is off by 10 degrees, that's a big deal. If it's 40% humidity instead of 50% humidity, it's not a big deal.

As for options or corners not to cut, I'm not really aware of any that make an enormous difference. There's basically two kinds: ones that spray cold water, and ones that heat the water and spray steam. Both will get the job done. Some claim the steam ones are better since the water's already in gas form, but it really doesn't make a practical difference. The primary way people go wrong with them is solved by reading the instructions.

One option you may want to consider is a shower-mounted humidifier. Basically, you stick it just behind the shower head, and it sprays a mist of cold water into the air. While you're running it, turn the fan on for your heat pump so it circulates the air throughout your house (the fan can be run independently from the heating and cooling). That would be a pretty fast and cheap way to figure out if a whole-house humidifier is worth the cost and effort.

Ruby the Liberal

(26,331 posts)
4. Ah! Interesting and very helpful.
Sun Mar 25, 2012, 08:34 PM
Mar 2012

I was curious about the water supply. As luck would have it, the AC/HP unit is on the opposite side of the house from any plumbing, so there is that.

Thanks for noting the shower option. I will follow up on this over the next week and hopefully have a plan.

Latest Discussions»Culture Forums»DIY & Home Improvement»Adding a humidifier to a ...